The 200W wind turbine is supplied as a complete kit. The only other things you
will need to install this unit are: a set of deep cycle batteries (which we can
supply, if required), a diversion load controller and cement for the foundations.
The following items make up the 200W wind turbine kit ...............
  • 3 section tower, labelled upper, middle and lower
    (each 1.3m long):
  • Tail-section  including 6 bolts for fin;
  • 3 blades;
  • Footing for the tower, including pivot
    bolt;
  • Wind turbine body including cabling
    and bolt for tail;
  • Blade hub with 6 bolts and
    restraining pieces
  • Fin;
  • A nose cone;
  • 3 catenary wire pieces for stays;
  • 6 U bolts to secure catenary wire;
  • 2 round spikes for securing footing;
  • 3 angled pegs to secure catenary
    wire to ground;
  • 3 turnbuckles with hook and eye
    ends;
  • Rectifier/regulator unit
  • A 24v power inverter
    (300w)
BOX 1
BOX 2
BOX 3
WELCOME TO BOB STRATFORD
ALTERNATIVE ENERGY
200w Wind turbine kit
(12/24v)
Counter
Rated power
200w
Max power
300w
Output DC voltage
12v/24v
Start wind speed
3m/s
Rated wind speed
6m/s
Max wind speed
40m/s
Cut out wind speed
None
Blade pitch control
None, fixed pitch
Overspeed protection
Auto furl
Gearbox
None, direct drive
Temperature range
-40 to +60 Deg.C (-40 to +140 Deg.F)
Rotor diameter
2.20m
Rotor speed
450rpm
Blade
3
Blade material
Reinforced fibre glass
Height of tower
4.5m
Generator
3 phase permanent magnet alternator
Sine Inverter power output
AC110/240v, 50HZ/60HZ
Weight
75kg
 
Three cartons...
72x42x22cm, 158x20x14cm, 36x27x15cm